Pull Locks
The Pull-Lock can be concealed in your posts and is a non-tensioning swageless device. It must be used with a tensioning device on the other end of your cable. The Pull-Locks can be used on straight cable spans or inclines and are available for 1/8, 3/16, and 1/4 cable. This fitting will need enough clearance on the back side of your end post to install the Pull-Lock into your pre-drilled hole, the clearance depends on length you decide is best for your application. The cable will need to be pulled through the pull lock, cut the cable off even at the end of the Pull-Lock, install the cap, then tension cable from the other side.
For specific questions, contact Jack Blair at (832) 928-9655.








