Adjust-a-Body with Threaded Clevis

Adjust-a-Body with Threaded Clevis can be used with any fitting on the opposite end of the run. This consists of two separate pieces: the articulating threaded bolt and adjust-a-body® tensioning body.

The threaded clevis is installed into a pre-drilled or tapped hole in the end post. The cable is retained within the body portion of the fitting by a ferrule swaged onto the end of the cable. The use of this fitting requires an appropriate-sized ferrule that is swaged onto the cable, which much be purchased separately.

Then, once sufficient tension is achieved, the lock nut is secured against the end of the body to secure the fitting from loosening.

For specific questions, contact Jack Blair at (832) 928-9655.

Adjust-a-Body Threaded Clevis
Blair Corporation 832-928-9655
adjust-a-body with threaded clevis