Invisiware Receiver Part # 516BC-R1252

FABRICATION OF NEW CABLE

  • Measure rail from outside of termination post to outside of termination post.
  • Subtract Take off from chart below depending on style of cable.
  • Cut cable to length.
  • Swage fittings onto cable.

516BC-R1252

**NOTE** Position the (threaded) stud onto the cable as shown.

SLIGHTLY LESS THAN CABLE DIAGRAM

Part (Side A)Part (Side B)Take Off
516BC-R1252 (3.030” LONG)516BC-R1252 (3.030” LONG)2 3/4
516BC-R1252 (3.030” LONG) w/ Beveled Washer516BC-R1252 (3.030” LONG)2 3/8
516BC-R1252 (3.030” LONG) w/ Beveled Washer516BC-R1252 (3.030” LONG) w/ Beveled Washer2

Single Side Take Off
PartTake off
516BC-R1252 (3.030” LONG)1 3/8
516BC-R1252 (3.030” LONG) w/ Beveled Washer1