Invisiware Receiver Part # 18BC-R642

FABRICATION OF NEW CABLE

  • Measure rail from outside of termination post to outside of termination post.
  • Subtract Take off from chart below depending on style of cable.
  • Cut cable to length.
  • Swage fittings onto cable.

**NOTE** Position the (threaded) stud onto the cable as shown.

invisiware receiver 18BC-R642

SLIGHTLY LESS THAN CABLE DIAGRAM

Part (Side A) Part (Side B) Take Off
18BC-R642 (2.30” LONG) 18BC-R642 (2.30” LONG) 2-1/8
18BC-R642 (2.30” LONG) w/ Beveled Washer 18BC-R642 (2.30” LONG) 1-13/16
18BC-R642 (2.30” LONG) w/ Beveled Washer 18BC-R642 (2.30” LONG) w/ Beveled Washer 1-1/2
Single Side Take Off
Part Take off
18BC-R642 (2.30” LONG) 1-1/16
18BC-R642 (2.30” LONG) w/ Beveled Washer 3/4